How it Works

Step 1: Slide It On

After you have purchased your DryPro cast cover and sized it to fit appropriately, simply stretch it on so that it completely covers the cast or bandage plus an additional inch. The top should be smooth against the skin. If the cover feels too tight you may trim the top slightly to increase the opening size. Be careful of sharp objects and fingernails.

 

Step 2: Pump It Out

Now it’s time to simply pump out the air using the attached hand-held bulb. Continue to press the bulb until it remains flat and the DryPro waterproof cast cover is completely wrinkled. Then just remove the pump and push on the safety cap.

Observe the DryPro waterproof cast and bandage cover for a few minutes before going in the water. As long as it stays collapsed and wrinkled, the vacuum is intact and the cast cover cannot leak or come off.

Step 3: Slide It Off

When you are done using the DryPro and are no longer near water, simply lift up the cuff to break the seal and let air back in. The DryPro waterproof cast cover should now be loose and allow you to simply slide it back off.

It’s that simple!

DryPro Leg Protector Demonstration


DryPro Arm Protector Demonstration


DryPro PICC Line Protector Demonstration


Notes: Do not leave the DryPro on for extended periods of time. We recommend removing it after every 45 minutes of use. Do not use in vascular compromised patients. Steady yourself in wet slippery areas. Always follow your doctor’s advice